Field Controls Power Venter, Series: SWG, 170000 Btu/hr, 115 V, 1.7 A, 138 W, 4 in, 3000 rpm, 9 inch height x 9 inch W
Gas and oil heating appliances generate heat through the combustion of fuel. The heat is transferred through the heat exchanger and distributed to the conditioned space. The products of combustion, however, must be vented safely out of the structure. inch a conventional chimney, venting is achieved by the natural lifting action of the hot combustion gas. New, efficient systems absorb more of the heat inch the heat exchanger and produce lower temperature vent gas. Lower temperature gas does not rise as quickly or as reliably as inch older, less efficient systems. Power venting or sidewall venting is more economical and safer than chimney venting. A power venter uses a motorized blower to vent the products of combustion. A power venter is interlocked with the appliance to ensure that proper draft is achieved before the appliance burner is activated.
Features
Features
Amperage Rating: 1.7 A
Vent/Duct Size: 4 in
Dimensions: 9 in H x 9 in W
The SWG or ComboVent power venter is the safest, most efficient power venter available today
The SWG or ComboVent must be sized to match the appliance or appliances input firing rate
Most firing rates are published in the manufacturer's installation manual
The SWG and ComboVent must be installed with a CK control kit to ensure proper listing and safe, efficient venting
Thermal protection
1.1 gph maximum oil at 100 psi
0.9 gph maximum oil at 140 psi
35 Btu/hr at maximum equivalent feet of vent pipe
100 Btu/hr at 60% of maximum equivalent feet of vent pipe
60 Hz frequency
170000 Btu/hr gas input
Patented SWG or ComboVent power venters are ETL and cETL listed for all LP gas, natural gas or oil-fired heating equipment
The SWG or ComboVent combines the motor, blower and vent hood in one complete, easy to install unit
The SWG mounts on the outside of the building and pulls the combustion gases from the appliance through the outside wall utilizing 100% negative pressure
100% negative pressure in the vent pipe for maximum safety
Standard galvanized pipe can be used instead of expensive stainless steel
No need to seal vent pipe joints, saving time and money
Significantly longer vent lengths than positive pressure, direct vent systems
The SWG or ComboVent is recommended by major heating appliance manufacturers
